TOB-1250
Tunnel-Type Overhead Rail Shot Blast Machine

Operation principle:

The work piece is hung on the cliver , the cliver is entered and thrown in a room automatically, interval position settled replies the sport. The rotation that the cliver does not stop under roller chain drive, so guarantee that each position of work piece on clivers is fully thrown and shot, Reduce and throw and penetrate the dead angle .
Dispose five and hang clivers , a cliver throws penetrating in throwing and penetrate the room,a cliver stops unloading the work piece in unloading worker's location of the material after throwing pills, another cliver waits to work in front of throwing a room. Other the second cliver can be put and hang the work piece .
Throw the steel pill after penetrating , flow from throwing the chink of indoor bar of pill, then transport to vibration sorting while sifting through two machines that sends spiral ,at steel flying in the pill, incidental go on and divide and sift and filter, send the steel pill to the lifting machine. Give at full curtain types in the separator, at steel sand ones in the pill, and small incidentals separate and go out dust lifting machine. The steel pill is thrown and penetrates to two on the surface after throwing an machine to accelerate.
The cliver is entered and thrown in a room, throw two side doors of room to close automatically, the electric apparatus is locked, in order to prevent work pieces from openning to throw the door of a room while throwing pills in throwing a room.
Throw the times of treatment definitely, throw pill show out when finishing but at time that preset in advance one, Combine bees to ring the sound of the newspaper one period later.
Throw the goalkeepers of both sides of a room to open automatically after throwing an electrical machinery and stop turning round, roller chains are started and throw the work piece penetrated to be taken out of and throw a room to mainly turn round, throw work piece that penetrate carry into and throw a room, finish one period at the same time.
This equipment is operated automatically besides upper and lower work pieces.
This equipment very ideal result of use device dust removal, adopt advanced straining core and add air recoil by pulse at a lot of at present, Epurate the working environment .

Scope of application:

Automobiles, motorcycles, fabrics machines, machine manufacturings ,etc. the trades one aluminium alloy die casting, clean on the precise casting of stainless steel, surface of the ferrous metal casting, the mere decorations, strengthenning.
Characteristic:

1、Consult a machine of throwing in the 1990s of Italian CM company
2、It throws head adopt direct electronic to urge person who unite electrical machinery transfer speed electrical machinery for frequency conversion, permanent power output.
3、Steel control can trace regulate valve, pneumatic to turn on and close by balls of flow.
4、Adopt the section of thick bamboo pulse blowback type dust remover of core.
5、Adopt PLC and control electrically.
6、It is reliable to operate simple, workly.
7、Design in the world hole .

Technical parameter：